Difference between revisions of "Digital End Code detection"
From The RadioReference Wiki
m |
|||
Line 1: | Line 1: | ||
Note that this function is not available in version 1.xx.xx firmware | Note that this function is not available in version 1.xx.xx firmware | ||
+ | ==Version 3.x.x Firmware== | ||
+ | To activate the new "digital end code detection" feature - which is distinctly different from | ||
+ | the "end code" option that is readily available in the radio's standard menu <br> | ||
+ | |||
+ | * Press '''Menu''' | ||
+ | * Select '''Program System''' | ||
+ | * Scroll to the system in question (i.e. Baltimore City). Select it. | ||
+ | * Scroll to & select '''Edit Sys Option''' | ||
+ | * Scroll to '''Set End Code''' and select this. | ||
+ | * Change from the default of ''ignore'' over to '''Analog + Digital'''. | ||
+ | * Then, just get out of menu. | ||
+ | |||
+ | This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with. <br> | ||
==Version 2.x.x Firmware== | ==Version 2.x.x Firmware== |
Revision as of 23:06, 5 October 2008
Note that this function is not available in version 1.xx.xx firmware
Version 3.x.x Firmware
To activate the new "digital end code detection" feature - which is distinctly different from
the "end code" option that is readily available in the radio's standard menu
- Press Menu
- Select Program System
- Scroll to the system in question (i.e. Baltimore City). Select it.
- Scroll to & select Edit Sys Option
- Scroll to Set End Code and select this.
- Change from the default of ignore over to Analog + Digital.
- Then, just get out of menu.
This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with.
Version 2.x.x Firmware
To activate the new "digital end code detection" feature - which is distinctly different from
the "end code" option that is readily available in the radio's standard menu
- Turn off the radio.
- Press the HOLD button and turn on the radio again. Once the radio boots, release HOLD
- Press Menu
- Select Program System
- Scroll to the system in question (i.e. Baltimore City). Select it.
- Scroll to & select Edit Sys Option
- Scroll to Digital End Code and select this.
- Change from the default of ignore over to Yes.
- Then, just get out of menu.
- Could then turn radio off & back on again (to again get into regular operating mode).
This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly,
the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every digital system you are having this issue with.
comment: This likely applies to the 996 as well (ka3jjz)
Thanx to DoctorDave in the Maryland Forum for this procedure