Difference between revisions of "10.7 MHz IF Output for the 2500"
From The RadioReference Wiki
m (updated categories) |
|||
(5 intermediate revisions by 4 users not shown) | |||
Line 1: | Line 1: | ||
+ | {{Back|IC PCR2500/IC-R2500}} | ||
+ | __NOEDITSECTION__ | ||
[[Image:PCR2500-1.jpg|thumb|right|Inside View After Taking Cover Off]] | [[Image:PCR2500-1.jpg|thumb|right|Inside View After Taking Cover Off]] | ||
Line 17: | Line 19: | ||
=== From the Icom Service Manual === | === From the Icom Service Manual === | ||
[[Image:PCR2500-Tap1-Doc.jpg]] | [[Image:PCR2500-Tap1-Doc.jpg]] | ||
+ | |||
+ | [[Category:Icom Receivers Modifications]] |
Latest revision as of 19:10, 10 February 2016
Notes from Lindsay Blanton
Word of warning - the tap point is extremely small, and not for the faint of heart. I actually went out and purchased a professional Weller Soldering iron and special soldering tip just for this task. Using the least amount of heat possible, I glued a pre-tinned small piece of wire next to the tap point, and then dragged some solder from the VERY small surface mount point to the wire. I then ran this 1 1/2 inch short length of wire up through the hole next to the center screw, and soldered some shielded cable to that for the run to the BNC connector.