Difference between revisions of "BC895XLT"
From The RadioReference Wiki
(added article on changing backlights) |
|||
| Line 3: | Line 3: | ||
User's Average Rating: 10.0 # of Ratings: 1<br> | User's Average Rating: 10.0 # of Ratings: 1<br> | ||
EXCELLENT ID TRACKER,VIRTUAL CONTROL, AND SCANNER PROGRAMER,ALL IN ONE WORKS VERY WELL WITH BC250D | EXCELLENT ID TRACKER,VIRTUAL CONTROL, AND SCANNER PROGRAMER,ALL IN ONE WORKS VERY WELL WITH BC250D | ||
| + | <br> | ||
| + | ==How to Change the Backlights== | ||
| + | from BryL on the BC895XLT Yahoo group | ||
| + | |||
| + | Take 5 screws off the top scanner cover (2 on each side and 1 on the back) then lift up the | ||
| + | cover from the back first and then detach it at the front. The speaker and wire will still | ||
| + | be attached to the scanner so you will have to gently pull the speaker wire plug out of the circuit board and set top cover aside. (You could leave it plugged in but the cover may be in the | ||
| + | way some) Then looking inside the scanner towards the display you will see 4 round white plastic | ||
| + | pieces with a slot in them. These are the back of lamp sockets. Turn the slot in each one counterclockwise about 1/8 to 1/4 turn until it stops and get a small needlenose pliers and | ||
| + | pull it straight out towards you. Some will come right out and some are a little stubborn and | ||
| + | need to be wiggled out. I always replace all 4 while I have it apart. Put in the new ones turn | ||
| + | 1/8 to 1/4 clockwise. Make sure the slots on all of them are horizontal. Don't forget to | ||
| + | plug your speaker wire back in and then put the cover back on and you'll be back in business. | ||
Revision as of 16:35, 23 September 2006
Radio Manager 2004 comments
User: mandlair Rating: 10 November 29, 2003
User's Average Rating: 10.0 # of Ratings: 1
EXCELLENT ID TRACKER,VIRTUAL CONTROL, AND SCANNER PROGRAMER,ALL IN ONE WORKS VERY WELL WITH BC250D
How to Change the Backlights
from BryL on the BC895XLT Yahoo group
Take 5 screws off the top scanner cover (2 on each side and 1 on the back) then lift up the cover from the back first and then detach it at the front. The speaker and wire will still be attached to the scanner so you will have to gently pull the speaker wire plug out of the circuit board and set top cover aside. (You could leave it plugged in but the cover may be in the way some) Then looking inside the scanner towards the display you will see 4 round white plastic pieces with a slot in them. These are the back of lamp sockets. Turn the slot in each one counterclockwise about 1/8 to 1/4 turn until it stops and get a small needlenose pliers and pull it straight out towards you. Some will come right out and some are a little stubborn and need to be wiggled out. I always replace all 4 while I have it apart. Put in the new ones turn 1/8 to 1/4 clockwise. Make sure the slots on all of them are horizontal. Don't forget to plug your speaker wire back in and then put the cover back on and you'll be back in business.