APCO-25 Reception Above 780 MHz

Return to IC PCR2500/IC-R2500 main page.

Overview

The Icom IC-R2500 and PCR2500 receivers offer excellent quality APCO-25 digital communications reception with the addition of the UT-122 plug in board. However, for an unknown reason Icom chose not to support reception above 780 MHz. However, thanks to Radio Reference member [bnravid[/b]] a relatively simple modification to restore reception above 780 MHz has been discovered. This modification will work with both the US (cellular blocked) and "Canadian" (unblocked) version of these receivers as well. It should also work with the model being sold from China by the eBay seller "palacemuseum".

Disclaimer

Radioreference and the persons involved in this modification will not be held liable for any damage done to your receiver if you perform this modification. Please proceed at your own risk with patience and caution. Thank you.

Required Tools

• Small (#1) phillips screwdriver.
• If using soldering iron, one with low heat and VERY small head.
• If not using soldering iron, tiny jeweler's screwdriver or dental pick.
• Beer or the drink of your choice prior to performing the mod (optional but recommended).

Procedure

• 1. Remove the top cover of the 2500. There are two small black phillips head screws on either side of the receiver, and four on its top. Place in a container so they don't "disappear". I've learned this one the hard way. Ouch.
• 2. Carefully remove the top of the receiver. It will be connnected to the interior by two molex cables, one for audio and one for power. I did not unplug them, but you may find it necessary.
• 3. With the front of the receiver towards you, your view will be similar to this one.

Note the red circle in the photo. This is the area in which you will perform the modification, which is the removal of a single diode. Here is a closer shot of the area in question.

Again, the area you will be working on is circled. Again, ENSURE that the front of the receiver is towards you. (Please note that in this photo the diode has already been removed)

• 4. Refer to the following diagram, which shows which diode must be removed to ensure APCO-25 digital reception above 780 MHz.

If you are using a soldering iron to remove the diode, you know what to do from here. If you are using the jeweler's screwdriver as I did, or a dental pick, very very carefully begin to "pick" at the diode. Patience and very careful "picking" will eventually (it took me about 15 minutes) remove the diode from the board without it flying into the guts of the radio. I then used a magnified screwdriver to remove the diode from the board.

• 5. Reassemble the radio.
• 6. Ensure that connections are made to the computer, and/or the remote head if using an R2500.
• 7. Run and test. If successful you will be able to access the P25 button (or mode if using the R2500 remote head) above 780 MHz.
• 8. That's it. Congratulations, you now have P25 reception above 780 MHz! Enjoy!

Other Information Sources

• BEWARE!!! R2500's from Japan - NO P25 Connector! thread.
• IC-PCR2500 & Apco P25 thread.

Acknowledgements

Thanks to the following individuals for their assistance with the discovery of this modification, the performance of this modification, and for providing the pictures used in this page:

• nravid - Discovered method of modification.
• John, W1PC - Performed modification and posted results, provided pictures.
• Inssomniak - Performed modification and posted results, provided pictures.
• Also, thanks to all others that have participated in the several long but informative threads regarding this and other 2500 issues. This page will be a work in progress with other photos and information added.

Scott/Scan Cape Cod

Return to IC PCR2500/IC-R2500 main page.