Actions

Difference between revisions of "Common Conventional Programming Questions"

From The RadioReference Wiki

(Category added)
Line 1: Line 1:
 +
* '''''''I am a railfan and would like to scan, what frequencies do they use?''''''' See [[Railroad frequencies]].
 +
 
*'''''''I see two frequencies for the agency I want to monitor, which one do I put in my scanner?'''''''
 
*'''''''I see two frequencies for the agency I want to monitor, which one do I put in my scanner?'''''''
 
**This would indicate one of two things in the RR Database.
 
**This would indicate one of two things in the RR Database.

Revision as of 13:56, 11 September 2007

  • ''I see two frequencies for the agency I want to monitor, which one do I put in my scanner?''
    • This would indicate one of two things in the RR Database.
      • If the channel is listed with a R in the Type column, then just program one in the Frequency column.
      • If the channel is listed with a B or BM in the Type column, then you really need to program both, as this would indicate this is a Duplex channel, where normally the base station will be on the frequency designated in the Frequency column and the mobile will be on the frequency in the Input column.
  • ''There is a column called Tone and it has funny numbers in it, do I need to worry about this?''
    • It all depends. What those are, are CTCSS and DCS values. If your scanner can accept them it will reduce outside interference from what you are interested in hearing. This means the agency you are programming uses that tone (or code) to limit reception/interference from other agencies that may be licensed on that frequency. Some scanners cannot use these tones and some agencies do not use them either. It really comes down to a personal choice on your part.

Return to the Common Programming Questions
Return to the RR FAQ page.