Connect the SDRPlay RSPs via TCP IP to Multipsk
From The RadioReference Wiki
Revision as of 13:01, 11 November 2019 by Ka3jjz (Created page with "==Notes== * This capability started with version 4.39.10. As always, be sure to get the most up to date version from the website * These instructions are built around the RSP...")
- This capability started with version 4.39.10. As always, be sure to get the most up to date version from the website
- These instructions are built around the RSP1; for the RSP2 (maybe other SDRPlay RSPs, too), it appears you need to start RSP_TCP.exe first, but this needs confirmation
- A PC with some horsepower is needed for using TCP/IP. A PC with at least a 1 Ghz processor is a good starting point
- You will need the TCP Server app, which can be found in the SDRPlay downloads page. Instructions on using the app are also there.
When you push the SDRPlay button (figure 1), an I/Q signal will be sent through the TCP/IP server using rsp_tcp.exe. According to tests, it works with Windows 10 and possibly earlier versions of Windows.
The sampling frequency is 250 Khz (except for ADS-B, which uses a 2 Mhz sampling frequency).
The default TCP/IP parameters are given below; they can be changed by clicking the Options (port/adress) button, which is found immediately below the SDRPlay button (figure 1).
- The default address is 127.0.0.1. To use another server, paste the server IP address here
- The default port is 1234. but it can be changed with the spin button. Valid values are from 1231 to 1250. This allows the use of several occurrences of Multipsk, each one connected to a different server and receiver.
If you wish to listen to the demodulated sound, click on the +Speaker button
Once you press the RX/TX Screen button, you can use the Transceiver form to control the frequency and gain. Note that the TX button on this form won't function (figure 2). In addition, references to Ham Radio Deluxe and Commander can be safely ignored.
To make this interface possible, several files must be copied to the Multipsk directory:
- msvcr100.dll Note: If you dont have this, it can be found here
- pthreadVCE2.dll Note: If you dont have this, it can be found here
- vcruntime140.dll Note: If you dont have this, it can be found here
- rsp_rcp.exe (thanks to F4FHH Nicolas and SDRplay)
For RSP2 users; by clicking on the "RSP2 bias-tee", the bias-tee (4.7 V / 100 mA max at the ANT-B antenna output) can be set (On) or reset (Off). Note that this option is not stored, so, you must manually set this option each time Multipsk is started.
You can add parameters to RSP_RCP.exe using a text editor. Insert them after the Parameters: caption. These parameters don't control the digital deocding function, rather they are used to address the SDRPlay hardware. Examples include;
-P0 for PORT A
-P1 for PORT B
-P2 for PORT HIz
For further details, read the SDRPlay RSP TCP Server Guide (note this is a PDF file)
The following options are not used. Note that MultiPSK doesn't check the user parameters to see if they are correct;
- Multipsk sdr settings.jpg
Figure 1 - click to enlarge