Actions

Difference between revisions of "Digital End Code detection"

From The RadioReference Wiki

m
Line 1: Line 1:
 
Note that this function is not available in version 1.xx.xx firmware
 
Note that this function is not available in version 1.xx.xx firmware
 +
==Version 3.x.x Firmware==
 +
To activate the new "digital end code detection" feature - which is distinctly different from
 +
the "end code" option that is readily available in the radio's standard menu <br>
 +
 +
* Press '''Menu'''
 +
* Select '''Program System'''
 +
* Scroll to the system in question (i.e. Baltimore City). Select it.
 +
* Scroll to & select '''Edit Sys Option'''
 +
* Scroll to '''Set End Code''' and select this.
 +
* Change from the default of ''ignore'' over to '''Analog + Digital'''.
 +
* Then, just get out of menu.
 +
 +
This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with. <br>
  
 
==Version 2.x.x Firmware==
 
==Version 2.x.x Firmware==

Revision as of 17:06, 5 October 2008

Note that this function is not available in version 1.xx.xx firmware

Version 3.x.x Firmware

To activate the new "digital end code detection" feature - which is distinctly different from the "end code" option that is readily available in the radio's standard menu

  • Press Menu
  • Select Program System
  • Scroll to the system in question (i.e. Baltimore City). Select it.
  • Scroll to & select Edit Sys Option
  • Scroll to Set End Code and select this.
  • Change from the default of ignore over to Analog + Digital.
  • Then, just get out of menu.

This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with.

Version 2.x.x Firmware

To activate the new "digital end code detection" feature - which is distinctly different from the "end code" option that is readily available in the radio's standard menu

  • Turn off the radio.
  • Press the HOLD button and turn on the radio again. Once the radio boots, release HOLD
  • Press Menu
  • Select Program System
  • Scroll to the system in question (i.e. Baltimore City). Select it.
  • Scroll to & select Edit Sys Option
  • Scroll to Digital End Code and select this.
  • Change from the default of ignore over to Yes.
  • Then, just get out of menu.
  • Could then turn radio off & back on again (to again get into regular operating mode).

This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every digital system you are having this issue with.

comment: This likely applies to the 996 as well (ka3jjz)
Thanx to DoctorDave in the Maryland Forum for this procedure