Difference between revisions of "Digital End Code detection"
From The RadioReference Wiki
(clarified that this is for Motorola Type II systems.) |
|||
Line 29: | Line 29: | ||
This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, | This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, | ||
− | the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every | + | the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with. <br> |
comment: This likely applies to the 996 as well (ka3jjz) <br> | comment: This likely applies to the 996 as well (ka3jjz) <br> |
Revision as of 18:09, 5 October 2008
Note that this function is not available in version 1.xx.xx firmware
Version 3.x.x Firmware
To activate the new "digital end code detection" feature:
- Press Menu
- Select Program System
- Scroll to the system in question (i.e. Baltimore City). Select it.
- Scroll to & select Edit Sys Option
- Scroll to Set End Code and select this.
- Change from the default of ignore over to Analog + Digital.
- Then, just get out of menu.
This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with.
Version 2.x.x Firmware
To activate the new "digital end code detection" feature - which is distinctly different from
the "end code" option that is readily available in the radio's standard menu
- Turn off the radio.
- Press the HOLD button and turn on the radio again. Once the radio boots, release HOLD
- Press Menu
- Select Program System
- Scroll to the system in question (i.e. Baltimore City). Select it.
- Scroll to & select Edit Sys Option
- Scroll to Digital End Code and select this.
- Change from the default of ignore over to Yes.
- Then, just get out of menu.
- Could then turn radio off & back on again (to again get into regular operating mode).
This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly,
the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with.
comment: This likely applies to the 996 as well (ka3jjz)
Thanx to DoctorDave in the Maryland Forum for this procedure