Actions

Difference between revisions of "Milcom Receiving Equipment"

From The RadioReference Wiki

(Added numerous AOR, Alinco radios via Wiki pages)
(fix PCR100/1000 redirects)
Line 133: Line 133:
 
<br>
 
<br>
 
* These receivers require the use of a PC to be useful  
 
* These receivers require the use of a PC to be useful  
**[[PCR-1000/100]]
+
**[[IC-PCR100]]
 +
**[[IC-PCR1000]]
 
**[http://www.strongsignals.net/access/reviews/reviews.cgi?type=display&rtype=rev&class=recv&num=027 Optocom Review at Strong Signals]  
 
**[http://www.strongsignals.net/access/reviews/reviews.cgi?type=display&rtype=rev&class=recv&num=027 Optocom Review at Strong Signals]  
 
**[[WinRadio]]
 
**[[WinRadio]]

Revision as of 07:17, 1 May 2007

Receivers/Scanners

Mini Handhelds

Care should be used when connecting any large antenna to these handhelds. Receivers in this range will likely overload, as their front ends simply can't handle the amount of RF such antennas may deliver. They are most useful in airshows, or if a base is geographically close to the user. A good set of earphones is strongly recommended.

Handhelds (full size)

  • Note 1 Programming UHF military air frequencies in the PRO-96 is only possible using Win96. In addition, sensitivity may not be optimum because the receiver was not designed for it. It's operation is otherwise normal in all other respects.
  • Note 2 In the November 2004 edition of Monitoring Times magazine, in the 'Scanner Equipment' column, author Bob Parnass AJ9S noted a pronounced loss of sensitivity in the 280-295 Mhz range.
  • Note 3 Icom receivers typically have a slow scan rate. Scanning large lists of frequencies effectively may not be possible. Software such as Radiomax may increase the available scan rate.
  • Note 4 Computer control and other logging functions using RS/GRE radios is not possible. Only up/download operations are supported.

Base/Mobile

  • Note 1 Programming UHF military air frequencies in the PRO-2096 is only possible using Win96. In addition, sensitivity may not be optimum because the receiver was not designed for it. It's operation is otherwise normal in all other respects.
  • Note 2 The BC895XLT cannot receive the 138-144 mhz range in AM mode. The BC898T is capable of this operation
  • Note 3 Icom receivers typically have a slow scan rate. Scanning large lists of frequencies effectively may not be possible. Software such as Radiomax may increase the available scan rate.
  • Note 4 Computer control and other logging functions using RS/GRE radios is not possible. Only up/download operations are supported.
  • Note 5 The PRO-2052 can be forced into AM mode in the VHF land mobile band (138-144 Mhz); a circuit modification is required

Computer Controlled Receivers



Other Sources of Reviews

Antennas

Also see our Scanner Antennas page for other links.


  • Picking the right coax for your setup is very important. As you go higher in frequency, the loss from a cheap cable can be significant. Here's a good page on the subject.

Filters

For those living in urban areas, putting up a good antenna (with the proper coax) can cause overloading. Sometimes this overloading shows up as pagers and other unwanted signals showing up in places where you don't want to hear them. These links show a few manufacturers that make filters for specific problem areas of the spectrum;

Preamps/Splitters

Return to VHF/UHF_Military_Monitoring