Actions

PSR-800, Pro-668 and WS1080 Error Codes

From The RadioReference Wiki

Revision as of 15:50, 17 October 2020 by Ka3jjz (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
  • As these 3 scanners are basically identical, this data should be common for all 3 scanners.
Error Code Error Type Suggested Solution
01-00 General heap error Provide error code information to forum
01-01 Unable to allocate from heap Same as above
02-00 Unknown object type in data Use PC Application to delete any corrupted objects or create a new configuration
02-01 Unknown TSYS type in data Use PC Application to delete any corrupted TSYS objects or create a new configuration
03-00 No MicroSD Card inserted Ensure that a properly formatted MicroSD card is fully inserted and locked in the MicroSD slot.
03-01 General error initializing file system Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
03-02 Cluster size bad Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
03-03 Error reading MicroSD card Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
03-04 Error writing MicroSD card Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
03-05 MicroSD Card is full Reduce size of configuration, remove unnecessary audio recordings or switch to a MicroSD card with more capacity.
03-06 MicroSD Card is write protected Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
03-07 Mass storage mode is active Under normal conditions this error should not appear. Mass storage device mode is disabled when the scanner is connected to a computer and scanning. Disconnect the radio from the computer, wait a few seconds, then reconnect. Contact GRE Support if the problem persists.
03-08 Unknown MicroSD card read/write error Reinsert the MicroSD card to ensure it is fully inserted in locked in the MicroSD slot. If necessary, reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
04-00 Initialization error Provide error code information to forum
04-01 Initialization error Same as above
04-02 Firmware load error Same as above
05-00 Unable to load CONFIG__.BIN Reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
05-01 CONFIG__.BIN file error Reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
05-02 CONFIG__.BIN file error Reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.
05-03 CONFIG__.BIN file error Reformat the MicroSD card using the PC Application “Prepare SD Card for use” option. Replace the MicroSD card if the problem persists.