Actions

Programming the BCT-8 for Fleetnet

From The RadioReference Wiki

Revision as of 08:43, 31 December 2010 by Ka3jjz (talk | contribs) (Created page with "#Press and hold TRUNK for 1.5 seconds and select the bank you want to change. #Use the up or down key to select (Motorola Type2 VHF) ,then press E. #Use the up or down key to s...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
  1. Press and hold TRUNK for 1.5 seconds and select the bank you want to change.
  2. Use the up or down key to select (Motorola Type2 VHF) ,then press E.
  3. Use the up or down key to select base , then press E.
  4. Use the keypad to enter Configuration Block Number 1
  5. Use the keypad to enter a new Base Frequency of 141.015, then press E.
  6. Press the up arrow key and select for entering the Spacing Frequency.
  7. Use the keypad to enter a new Spacing Frequencyof 15.0, then press E.
  8. Press the up arrow key and select 380 for entering the OffsetChannel.


Thanks to Bullmax for the above