Difference between revisions of "Software Support for Uniden Rebanding"
From The RadioReference Wiki
| Line 33: | Line 33: | ||
* [http://www.proscan.org ProScan] | * [http://www.proscan.org ProScan] | ||
** '''Currently Supported: ''' BCD396, 996, BCT15, BC296D, BC796D, BCD396XT, BC346XT | ** '''Currently Supported: ''' BCD396, 996, BCT15, BC296D, BC796D, BCD396XT, BC346XT | ||
| − | * ARC396 | + | * [http://www.butelsoftware.com ARC396] |
| − | * ARC996 | + | * [http://www.butelsoftware.com ARC996] |
| − | * ARC246 | + | * [http://www.butelsoftware.com ARC246] |
| − | * ARC15 | + | * [http://www.butelsoftware.com ARC15] |
<br> | <br> | ||
* [http://www.bctool.org/ BCTool] not yet supported, but is expected to be in the near future | * [http://www.bctool.org/ BCTool] not yet supported, but is expected to be in the near future | ||
Revision as of 05:39, 13 April 2009
Please use this article to document how to enter the Rebanding changes outlined below in the various software packages that support Uniden scanners.
| Band Plan | Base Freq (lower) | Base Freq (upper) | Offset | Polarity | Spacing |
|---|---|---|---|---|---|
| 1 | 851.025 | 854.000 | 440 | + | 25 khz |
| 2 | 851.0125 | 868.9875 | 0 | + | 25 khz |
As of this writing, the following software packages are known to support rebanding. Note the scanners currently supported; all packages are expected to be upgraded for other scanners when Uniden releases the firmware.
- FreeScan
- FreeScan User Guide
- Currently Supported: BCD396, BCD996, BC246, BCT15, BCD396XT, BC346XT
- Scan Control
- Currently Supported: BCD396 and 996
- ProScan
- Currently Supported: BCD396, 996, BCT15, BC296D, BC796D, BCD396XT, BC346XT
- ARC396
- ARC996
- ARC246
- ARC15
- BCTool not yet supported, but is expected to be in the near future
FreeScan
To access this screen, change the site type to Mot Custom/Reband
Return to the Uniden DMA FAQ