Difference between revisions of "Software Support for Uniden Rebanding"
From The RadioReference Wiki
m |
m |
||
Line 36: | Line 36: | ||
* ARC996 (same) | * ARC996 (same) | ||
* ARC246 (same) | * ARC246 (same) | ||
− | + | * ARC15 (same) | |
<br> | <br> | ||
* [http://www.bctool.org/ BCTool] not yet supported, but is expected to be in the near future | * [http://www.bctool.org/ BCTool] not yet supported, but is expected to be in the near future | ||
− | |||
− | |||
− | |||
==FreeScan== | ==FreeScan== |
Revision as of 08:06, 19 February 2009
Please use this article to document how to enter the Rebanding changes outlined below in the various software packages that support Uniden scanners.
Band Plan | Base Freq (lower) | Base Freq (upper) | Offset | Polarity | Spacing |
---|---|---|---|---|---|
1 | 851.025 | 854.000 | 440 | + | 25 khz |
2 | 851.0125 | 868.9875 | 0 | + | 25 khz |
As of this writing, the following software packages are known to support rebanding. Note the scanners currently supported; all packages are expected to be upgraded for other scanners when Uniden releases the firmware.
- FreeScan
- FreeScan User Guide
- Currently Supported: BCD396, 996, 246, and BCT15
- Scan Control (version 7.0)
- Currently Supported: BCD396 and 996
- ProScan (version 1.83)
- Currently Supported: BCD396, 996 and BCT15
- ARC396 (version 3.0 - available from Scanner Master)
- ARC996 (same)
- ARC246 (same)
- ARC15 (same)
- BCTool not yet supported, but is expected to be in the near future
FreeScan
To access this screen, change the site type to Mot Custom/Reband
Return to the Uniden DMA FAQ