From The RadioReference Wiki
Configure New Teamspeak Server
- Click on Connections, then select Connect
- Right-Click on Servers, then select Add Server
- Give the new server a friendly name (example only: RR Teamspeak) and press <Enter>
- Fill out the details for that new server
The values you enter on the righthand side will vary depending upon the Teamspeak server you are connecting to.
Label: RR Teamspeak
The label should be a 'short' friendly name that you want it to show up as on the left
Server Address: 192.168.1.100:8767
8767 is the default port. If the server you want to connect to has a port of 8767, you can omit the : and everything after it. However, since many Teamspeak servers run on odd ports, it is better to always include the port as well. If a server doesn't list a port, then it is using the default port 8767.
Also, you may see a hostname in place of the IP address, example only: rrts.radioference.com:8768
The nickname should be something descriptive of you, perhaps your RR name, perhaps something else. Or, make it something totally obscure. Whatever you wish.
- Click Connect to connect to the server
If all goes well, you should be logged into the Teamspeak server and hear "Link Engaged." You should see something vaguely similar to what you see below.
Register With Server
Most Teamspeak servers require that you register with the server before you are able to access its channel contents. During this process you will be prompted for Login Name and a Password. Just make up something for each, but remember what they are because you will have to enter them in your configuration later.
- Click on Self, then Register With Server
- Make up a Login Name and Password and enter those in (password twice)
When finished, you will hear "Registration Complete" and should see the following at the bottom of your Teamspeak window:
Edit Your Teamspeak Config (now that you are registered)
- Select Connect, then select Disconnect. You should hear "Link Disengaged."
- Then, click on Connection, and then select Connect
Highlight the new entry you just created, and then edit the information on the right-hand side
- Select Registered instead of Anonymous
Login Name: Enter in the Login Name that you used when you Registered With Server
User Password: Enter in the Password that you used when you Registered With Servers
Connect To Server (to verify config and have fun)
You should hear "Link Engaged." You should also see an (R) to the rightside of your name as shown below:
If you've made it to this point, you are ready to enjoy listening to audio on the new Teamspeak server that you registered on. You might even want to go find some other Teamspeak servers to connect to. Many are mentioned in this thread in the RR Forums.
If you run into problems, you may want to ask for help in that forum or at GoTeamspeak