Inside View After Taking Cover Off
Lead wire from tap point to coax
Word of warning - the tap point is extremely small, and not for the faint of heart. I actually went out
and purchased a professional Weller Soldering iron and special soldering tip just for this task. Using
the least amount of heat possible, I glued a pre-tinned small piece of wire next to the tap point, and
then dragged some solder from the VERY small surface mount point to the wire. I then ran this 1 1/2
inch short length of wire up through the hole next to the center screw, and soldered some shielded
cable to that for the run to the BNC connector.
