Difference between revisions of "DIY Antenna Mounting Bracket"
From The RadioReference Wiki
Line 1: | Line 1: | ||
− | + | Get yourself some 1/4" thick aluminum about 8"X8" from your local metal supplier or similar hardware stores, those screws are not needed!. | |
+ | |||
+ | http://i21.photobucket.com/albums/b287/tonsoffun26/Aluminum.jpg | ||
+ | |||
+ | |||
+ | You will also need four 2 1/4" muffler clamps. | ||
+ | |||
+ | http://i21.photobucket.com/albums/b287/tonsoffun26/Mufflerclamp.jpg | ||
+ | |||
+ | You can buy smaller if you prefer but I would rather go a little bigger on the clamps so you can fit up to a 2" metal or aluminum mast if you chose. | ||
+ | |||
+ | |||
Take care | Take care | ||
Tonsoffun | Tonsoffun |
Revision as of 09:27, 23 October 2008
Get yourself some 1/4" thick aluminum about 8"X8" from your local metal supplier or similar hardware stores, those screws are not needed!.
You will also need four 2 1/4" muffler clamps.
You can buy smaller if you prefer but I would rather go a little bigger on the clamps so you can fit up to a 2" metal or aluminum mast if you chose.
Take care
Tonsoffun