Difference between revisions of "Discriminator output"
From The RadioReference Wiki
Line 2: | Line 2: | ||
Note that for providing a signal for ACARS applications, a plug from an earphone or speaker output is all that's required. This is because ACARS runs at a much lower speed, and the discriminator is not involved in AM reception. | Note that for providing a signal for ACARS applications, a plug from an earphone or speaker output is all that's required. This is because ACARS runs at a much lower speed, and the discriminator is not involved in AM reception. | ||
− | + | * See Bill Cheeks [[SCANDATA.FAQ]] listed at the bottom of the page for detailed instructions on how to tap the discriminator in your scanner and the locations of various tap points. | |
− | * See | ||
* See this [http://www.radioreference.com/digital/dig/bc895-tap.txt document] from Greg Knox regarding instructions on how to tap the discriminator output on the BC-895 Scanner. See this [http://www.radioreference.com/digital/dig/bc895-tap.jpg picture] for the location of the discriminator output on the 895. | * See this [http://www.radioreference.com/digital/dig/bc895-tap.txt document] from Greg Knox regarding instructions on how to tap the discriminator output on the BC-895 Scanner. See this [http://www.radioreference.com/digital/dig/bc895-tap.jpg picture] for the location of the discriminator output on the 895. | ||
− | |||
* Here are a few more sources of discriminator tap information; | * Here are a few more sources of discriminator tap information; | ||
** [http://www.discriminator.nl/index-en.html Disciminator NL] | ** [http://www.discriminator.nl/index-en.html Disciminator NL] |
Revision as of 17:25, 15 December 2005
The Discriminator output from a scanner is the raw, unfiltered signal that a scanner produces before it is sent to the audio stage for output through the speaker -- also called the "baseband audio." This discriminator source is required for applications such as Trunker, MTrunker, T4Win, and UniTrunker. Most scanners must have a simple modification made to them to output the discriminator audio output to Data Slicers, or in the case of UniTrunker, a soundcard.
Note that for providing a signal for ACARS applications, a plug from an earphone or speaker output is all that's required. This is because ACARS runs at a much lower speed, and the discriminator is not involved in AM reception.
- See Bill Cheeks SCANDATA.FAQ listed at the bottom of the page for detailed instructions on how to tap the discriminator in your scanner and the locations of various tap points.
- See this document from Greg Knox regarding instructions on how to tap the discriminator output on the BC-895 Scanner. See this picture for the location of the discriminator output on the 895.
- Here are a few more sources of discriminator tap information;