Difference between revisions of "Programming the BCT-8 for Fleetnet"
From The RadioReference Wiki
(Created page with "#Press and hold TRUNK for 1.5 seconds and select the bank you want to change. #Use the up or down key to select (Motorola Type2 VHF) ,then press E. #Use the up or down key to s...") |
m (updated categories) |
||
(2 intermediate revisions by the same user not shown) | |||
Line 10: | Line 10: | ||
<small>Thanks to Bullmax for the above</small> | <small>Thanks to Bullmax for the above</small> | ||
− | + | ||
− | [[Category:Regional Programming]] | + | [[Category:Ontario Regional Programming]] |
Latest revision as of 00:10, 2 August 2015
- Press and hold TRUNK for 1.5 seconds and select the bank you want to change.
- Use the up or down key to select (Motorola Type2 VHF) ,then press E.
- Use the up or down key to select base , then press E.
- Use the keypad to enter Configuration Block Number 1
- Use the keypad to enter a new Base Frequency of 141.015, then press E.
- Press the up arrow key and select for entering the Spacing Frequency.
- Use the keypad to enter a new Spacing Frequencyof 15.0, then press E.
- Press the up arrow key and select 380 for entering the OffsetChannel.
Thanks to Bullmax for the above