ScannerCast Setup Instructions

Software Required

• ScannerCast Free, supply your RadioReference.com username and password to have it configure itself.

Quick Start to Launch and Stream

1. Launch ScannerCast.
2. Select your scanner model. Select Audio Only if you are not sending tags.
3. If you're sending tags, select the COM port that's connected to your scanner.
4. Select the "Icecast" tab at the top.
5. Check "Send Stream To Icecast".
6. Check "Auto-Configure my RR Feed".
7. Enter your RR user name and password.
8. Click "Login To Get RR and get config".
9. After you see the green check beside "Feed To Send" chose your feed.
10. Press "Start Broadcast".

Note: You may have to allow ScannerCast through your firewall.

Advanced Setup Instructions:

Config Tab:

• Server: Stream Name: Enter the name of your feed.
• Server Port: Leave as is unless you need to change it.
• Audio: Sound Input: Select the Sound input for your computer. Note: It is best to select a specific sound card/input and not "Primary Sound Capture Driver".
• Audio: Set MP3 Bit Rate to 16kbs for a mono stream or 32kbs for a stereo (dual scanner) stream.

Change your feed Display Name:

1. Select the "Config" Tab.
2. Press "Stop Broadcasting".
3. Enter the name of your feed into the "Stream Name" text box.
4. Click "Start Broadcasting" -- this saves the settings and restarts your stream.

ScannerCast will now send your feed title instead of "K1PGV ScannerCast!".

Everyone will now know it is your stream they are listening to when they use any of the players.

Icecast Tab:

• Use Quick Set up instructions to auto config your feed.
• For manual, input the needed info.

Status Tab:

No changes needed

Advanced Tab:

Tag Formatting and Audio Options: Check Enable Stereo Input if you are doing a stereo (dual scanner) feed.

For More Information on Configuration and Setup

See the author's configuration page at this link for visual (and more advanced) setup instructions.