Uniden Headphone Jack Modification
From The RadioReference Wiki
This modification describes a procedure that can be used if you plugged headphones or a speaker into the speaker out on the BCD996T, and you later find out that the audio has gone dead.
NOTE: Performing this modification voids the warranty
NOTE: This modification will disable the muting of the speaker output when headphones are plugged in
- First remove the black case surround (figure 1)
- The internal case around the headphone jack needs to be opened. Remove the highlighted screws on both sides (figure 2)
- Then place a bead of solder between the two posts as shown in the red box, these are the #2 and #3 posts when referencing the case as a starting point. (figure 3)
Thanks to canav844 for posting this modification