Uniden Headphone Jack Modification

This modification describes a procedure that can be used if you plugged headphones or a speaker into the speaker out on the BCD996T, and you later find out that the audio has gone dead.

NOTE: Performing this modification voids the warranty

NOTE: This modification will disable the muting of the speaker output when headphones are plugged in

• 

  Figure 1

• 

  Figure 2

• 

  Figure 3

1. First remove the black case surround (figure 1)
2. The internal case around the headphone jack needs to be opened. Remove the highlighted screws on both sides (figure 2)
3. Then place a bead of solder between the two posts as shown in the red box, these are the #2 and #3 posts when referencing the case as a starting point. (figure 3)

Thanks to canav844 for posting this modification