Difference between revisions of "Tonsoffun"
From The RadioReference Wiki
Line 1: | Line 1: | ||
− | This Log Periodic beam is very easy to build yourself with the available material at your local hardware store. The design is from a | + | This Log Periodic beam is very easy to build yourself with the available material at your local hardware store. The design is from a Haruteq Scanner Book I had and decided to give it a try. It works great on all scanner bands when you need to pin point and maximize your signal. The design shown is uni-directional and suitable for mounting on a tower or mast with a rotor to change it's listening area whenever you like. |
− | + | ||
− | * | + | The specifications shown for the LP has an overall gain of about 8 to 10dB from about 130 Mhz to 900 Mhz, and has a 50 Ohm impedance. Below 130 Mhz it actually performs quite well on local signals and strong skip, although no miracles can be expected. |
− | * | + | |
+ | Parts you need to make this antenna: | ||
+ | * Two lenghts of aluminum (#1 on drawing below)to make the boom (preferably square or even angle) 1 meter long (3' and a bit)and diameter about 1/2" to 3/4". | ||
+ | * Antenna elements should be about 3 to 4mm (about 1/8") Strong enough that the wind can not bend it. The elements that I put on were 1/4" to make it really beefy. All together you are going to need about 6 m (20')of the element material. | ||
+ | * U-clamp (#3 on the drawing) | ||
+ | * Pieces of wood or plexi glass to keep the booms seperated | ||
+ | * Small wire to jumper the back of the LP | ||
+ | * Some very good coax to hook up to your scanner | ||
http://i21.photobucket.com/albums/b287/tonsoffun26/LogPerodic.jpg | http://i21.photobucket.com/albums/b287/tonsoffun26/LogPerodic.jpg |
Revision as of 18:26, 21 February 2008
This Log Periodic beam is very easy to build yourself with the available material at your local hardware store. The design is from a Haruteq Scanner Book I had and decided to give it a try. It works great on all scanner bands when you need to pin point and maximize your signal. The design shown is uni-directional and suitable for mounting on a tower or mast with a rotor to change it's listening area whenever you like.
The specifications shown for the LP has an overall gain of about 8 to 10dB from about 130 Mhz to 900 Mhz, and has a 50 Ohm impedance. Below 130 Mhz it actually performs quite well on local signals and strong skip, although no miracles can be expected.
Parts you need to make this antenna:
- Two lenghts of aluminum (#1 on drawing below)to make the boom (preferably square or even angle) 1 meter long (3' and a bit)and diameter about 1/2" to 3/4".
- Antenna elements should be about 3 to 4mm (about 1/8") Strong enough that the wind can not bend it. The elements that I put on were 1/4" to make it really beefy. All together you are going to need about 6 m (20')of the element material.
- U-clamp (#3 on the drawing)
- Pieces of wood or plexi glass to keep the booms seperated
- Small wire to jumper the back of the LP
- Some very good coax to hook up to your scanner