Difference between revisions of "Discriminator output"
From The RadioReference Wiki
Line 1: | Line 1: | ||
− | The Discriminator output from a scanner is the raw, unfiltered signal that a scanner produces before it is sent to the audio stage for output through the speaker -- also called the "baseband audio." This discriminator source is required for applications such as Trunker, | + | The Discriminator output from a scanner is the raw, unfiltered signal that a scanner produces before it is sent to the audio stage for output through the speaker -- also called the "baseband audio." This discriminator source is required for applications such as [[Trunker]], [[T4Win]], and [[UniTrunker]]. Most scanners must have a simple modification made to them to feed the discriminator output to [[Data Slicers]], or in the case of [[UniTrunker]], a soundcard. |
Note that for providing a signal for ACARS applications, a plug from an earphone or speaker output is all that's required. This is because ACARS runs at a much lower speed, and the discriminator is not involved in AM reception. | Note that for providing a signal for ACARS applications, a plug from an earphone or speaker output is all that's required. This is because ACARS runs at a much lower speed, and the discriminator is not involved in AM reception. |
Revision as of 17:28, 15 December 2005
The Discriminator output from a scanner is the raw, unfiltered signal that a scanner produces before it is sent to the audio stage for output through the speaker -- also called the "baseband audio." This discriminator source is required for applications such as Trunker, T4Win, and UniTrunker. Most scanners must have a simple modification made to them to feed the discriminator output to Data Slicers, or in the case of UniTrunker, a soundcard.
Note that for providing a signal for ACARS applications, a plug from an earphone or speaker output is all that's required. This is because ACARS runs at a much lower speed, and the discriminator is not involved in AM reception.
- See Bill Cheeks SCANDATA.FAQ listed at the bottom of the page for detailed instructions on how to tap the discriminator in your scanner and the locations of various tap points.
- See this document from Greg Knox regarding instructions on how to tap the discriminator output on the BC-895 Scanner. See this picture for the location of the discriminator output on the 895.
- Here are a few more sources of discriminator tap information;