Cleaning the PSR-800 LCD Display
From The RadioReference Wiki
- Note: Click on the image to expand
- (Figure 1) The main problem when opening the PSR-800 is that the speaker leads are not long enough to allow both halves to lie flat
- (Figure 2) Open it too far and you will end up with the flexible ribbon from the keyboard being pulled from it's connector
- (Figure 3) A better approach is this - while holding the two halves at 90 degress, lift the tape that is on the speaker leads. Now the two halves can lie flat without any strain on the connector
- (Figure 4) Now you can remove the six screws holding the LCD assembly and remove that pesky dust
Thanks to ggraves and EvilLithiumMan for the procedure