Difference between revisions of "Digital End Code detection"
From The RadioReference Wiki
(clarified that this is for Motorola Type II systems.) |
m (Category added) |
||
Line 33: | Line 33: | ||
comment: This likely applies to the 996 as well (ka3jjz) <br> | comment: This likely applies to the 996 as well (ka3jjz) <br> | ||
<small>Thanx to DoctorDave in the Maryland Forum for this procedure</small> | <small>Thanx to DoctorDave in the Maryland Forum for this procedure</small> | ||
+ | |||
+ | Return to the [[Uniden DMA FAQ]] | ||
[[Category:DMA Radios Hints and Kinks]] | [[Category:DMA Radios Hints and Kinks]] | ||
+ | [[Category:Analog Trunktrackers]] | ||
+ | [[Category:Digital Scanners]] | ||
+ | [[Category:Programming FAQs and Tips for Uniden Scanners]] | ||
+ | [[Category:Location Based Scanning]] | ||
+ | [[Category:Scanners Glossary]] | ||
+ | [[Category:Software Glossary]] | ||
+ | [[Category:Trunktracking Glossary]] |
Revision as of 16:52, 15 May 2016
Note that this function is not available in version 1.xx.xx firmware
Version 3.x.x Firmware
To activate the new "digital end code detection" feature:
- Press Menu
- Select Program System
- Scroll to the system in question (i.e. Baltimore City). Select it.
- Scroll to & select Edit Sys Option
- Scroll to Set End Code and select this.
- Change from the default of ignore over to Analog + Digital.
- Then, just get out of menu.
This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly, the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with.
Version 2.x.x Firmware
To activate the new "digital end code detection" feature - which is distinctly different from
the "end code" option that is readily available in the radio's standard menu
- Turn off the radio.
- Press the HOLD button and turn on the radio again. Once the radio boots, release HOLD
- Press Menu
- Select Program System
- Scroll to the system in question (i.e. Baltimore City). Select it.
- Scroll to & select Edit Sys Option
- Scroll to Digital End Code and select this.
- Change from the default of ignore over to Yes.
- Then, just get out of menu.
- Could then turn radio off & back on again (to again get into regular operating mode).
This will allow the radio to move on from any given talkgroup once the unit has ended their transmission - and importantly,
the radio should no longer wait until the repeater un-sticks. You'll have to set this for each and every Motorola Type II system you are having this issue with.
comment: This likely applies to the 996 as well (ka3jjz)
Thanx to DoctorDave in the Maryland Forum for this procedure
Return to the Uniden DMA FAQ