Freescan Advanced Options
From The RadioReference Wiki
Revision as of 18:52, 13 October 2008 by Ka3jjz (talk | contribs) (New page: Image:FreeScan adv options.JPG ==GPS Settings== For additional information on Location based scanning, please see the following articles; * BCD996T Lat-Lon * DRD DXG POI * [[...)
Revision as of 18:52, 13 October 2008 by Ka3jjz (talk | contribs) (New page: Image:FreeScan adv options.JPG ==GPS Settings== For additional information on Location based scanning, please see the following articles; * BCD996T Lat-Lon * DRD DXG POI * [[...)
GPS Settings
For additional information on Location based scanning, please see the following articles;
These topics apply to the BCD396 and 996 with version 3.0 firmware or better;
AGC Control
- Due to firmware limitations, only one AGC may be modified at a time. This means that to change the Analog AGC settings, you must go into the scanner and turn off the digital AGC. Apply your changes to the Analog AGC settings, then upload. To change the digital AGC, the analog AGC must similarly be turned off, changes applied then uploaded.
- There is no 'Dynamic Range' setting for the digital AGC. This option only exists for the Analog AGC
P25 Wait Time
- This function is only available when the scanner is powered up in hidden menu mode. To access this mode, hold the HOLD key down while powering the scanner
Proceed to the Preferences article
Return to the Fire Tone Out article
Return to the Setup Scanner Options article