Actions

Difference between revisions of "VHF/UHF Military Monitoring"

From The RadioReference Wiki

(first cut at a new page)
 
 
(168 intermediate revisions by 17 users not shown)
Line 1: Line 1:
This page is an introduction for those new to the world of V/UHF military monitoring, as well as for folks more seasoned in the hobby.  
+
This page is an introduction for those new to the world of '''[[VHF]]''' and '''[[UHF]]''' military monitoring, as well as for folks more seasoned in the hobby. This topic is discussed in the [https://forums.radioreference.com/forums/military-monitoring-forum.94/ RadioReference Military Monitoring Forum]
  
==Receivers==
+
==Where to Start?==
 +
Even if you aren't around a military base, there's still several possibilities to hear Military Communications (Milcom) traffic:
  
===Computer Controlled===
+
; Tips
* [[PCR-1000/100]]
+
* Any data on military trunk systems is linked in the 'Trunked Radio Systems' page linked on each state's page in our [[Collaboration Gateway]]. For an example, see the [[Trunked Radio Systems (MD)]] article.
* [http://www.strongsignals.net/access/reviews/reviews.cgi?type=display&rtype=rev&class=recv&num=027 Optocom Review at Strong Signals]  
+
* If you live near a major city, chances are good your local airport also uses UHF frequencies in addition to the usual civil air ones. Be sure to check the RadioReference Database for these.
* [http://www.strongsignals.net/access/reviews/reviews.cgi?type=display&rtype=rev&class=recv&num=015 Winradio WR1000I Review at Strong Signals]
 
* [http://www.eham.net/reviews/detail/472 EHam opinions on the Winradio WR1500i]
 
* [http://www.eham.net/reviews/detail/1532 EHam opinions on the Winradio 1550e]
 
  
==Antennas==
 
* [http://www.strongsignals.net/access/content/antenna.html Strong Signals Antennas Page]
 
* Also see our [[Antennas]] page for other links.
 
* Picking the right coax for your setup is very important. As you go higher in frequency, the loss from a cheap cable can be significant. [http://www.strongsignals.net/access/content/co-ax.html Here's] a good page on the subject.
 
* [http://www.radioreference.com/forums/forumdisplay.php?f=80 RadioReference Antennas Forum]
 
* [http://strongsignals.net/access/forums/viewforum.php?f=17 Strong Signals Antennas Forum]
 
  
==Filters==
+
==Typical Questions and Answers==
For those living in urban areas, putting up a good antenna (with the proper coax) can cause overloading. Sometimes this overloading shows up as pagers and other unwanted signals showing up in places where you don't want to hear them. These links show a few manufacturers that make filters for specific problem areas of the spectrum;
+
* '''What Do I Need to Hear Military Flights?'''
 +
** See our [[Milcom Receiving Equipment]] article. It covers SDRs, scanners, wideband radios, and some examples of antennas
  
* [http://www.radiofilters.com Radiofilters.Com]
 
* [http://www.parelectronics.com/ Par Electronics]
 
 
 
==Preamps/Splitters==
 
* [http://www.stridsberg.com/ Stridsberg Engineering]
 
  
==Pages with Useful Information==
+
* '''Where Can I Find Information for my area?'''
* [http://24.61.250.39:89/slang.html Combat Air Patrol Glossary of Terms]
+
** The first place you should go is the RadioReference Database, which contains frequencies maintained by a team of specialists in their area.
* [http://www.radioinfosystems.com/links.htm Military Base frequencies]
+
** Then check the [[Milcom Web Pages and Mailing Lists]] article
* '''NOTE:''' These lists are at the bottom of the page, in Word format
 
* [http://henney.com/chm/callsign.htm Military Callsign List]  
 
* [http://www.milaircomms.com/ MilAir Comms]  
 
  
==Frequencies==
 
* [http://henney.com/chm/mid-lant.htm Mid Atlantic Area - Military Frequencies of Interest]
 
* [[Delmarva Milcom Monitoring]]
 
  
==Mailing Lists==
+
* '''How can I find what is being used for milcom in my area if the above has nothing.'''
* Also see the mailing lists on the [[Ute Listening]] page for additional links
+
** Post a question in your state's forum
* [http://mailman.qth.net/mailman/listinfo/milair Military Aircraft Comms]
+
** See the [[Searching for Milcom Activity]] article
* [http://mailman.qth.net/mailman/listinfo/milcom Milcom]
+
 
* [http://groups.yahoo.com/group/HiDesertScan/ Hi Desert Scan]
+
 
* [http://groups.yahoo.com/group/mil-spotters-forum/ Mil Spotters Forum]
+
* '''What About Satellites?'''
* [http://groups.yahoo.com/group/mid_atlantic_milcom/ Mid Atlantic Milcom]
+
* '''Can I Hear (and maybe talk to) the Astronauts on the International Space Station?'''
* [http://groups.yahoo.com/group/NAMAR/ NAMAR]
+
**Military communications over satellites can occasionally be heard.  Note that just about all U.S. military SATCOM voice transmissions are encrypted.  Occasionally you can hear short comms in the clear, like voice testing, but this is infrequent.  You can also hear telemetry and other constant data streams.  More often, you can hear what sounds like casual conversations in languages other than English, but the reason for this is somewhat unclear. A receiver for monitoring SATCOM must coverage from 240 MHz to 270 MHz. While NFM mode is common, many other modes are possible. [[Software Defined Radios]] easily fit this requirement. Just like VHF/UHF Milcom, SATCOM uses an interval of 25 kHz.  Optimal setups for receiving SATCOM are unique, involving hi gain antennas designed for correct polarization of the SATCOM signal. It is possible to hear SATCOM with nothing more than a handheld and a wideband whip. This technique involves going outside (SATCOM signals are relatively weak), searching the SATCOM frequency range, and experimenting with orienting your whip from vertical to horizontal. Listen carefully for carriers and periodic data bursts. See the [[SATCOM]] page for more information about amateur and military satellites, including the International Space Station.
* [http://groups.yahoo.com/group/ScannerTalk/ Scanner Talk]
+
 
 +
---
 +
*Return to: [[Main Page]]
 +
*Return to: [[Scanning Q%26A]]
 +
 
 +
[[Category:Military FAQ]]
 +
[[Category:Scanners FAQ]]

Latest revision as of 20:48, 28 November 2020

This page is an introduction for those new to the world of VHF and UHF military monitoring, as well as for folks more seasoned in the hobby. This topic is discussed in the RadioReference Military Monitoring Forum

Where to Start?

Even if you aren't around a military base, there's still several possibilities to hear Military Communications (Milcom) traffic:

Tips
  • Any data on military trunk systems is linked in the 'Trunked Radio Systems' page linked on each state's page in our Collaboration Gateway. For an example, see the Trunked Radio Systems (MD) article.
  • If you live near a major city, chances are good your local airport also uses UHF frequencies in addition to the usual civil air ones. Be sure to check the RadioReference Database for these.


Typical Questions and Answers

  • What Do I Need to Hear Military Flights?


  • Where Can I Find Information for my area?
    • The first place you should go is the RadioReference Database, which contains frequencies maintained by a team of specialists in their area.
    • Then check the Milcom Web Pages and Mailing Lists article


  • How can I find what is being used for milcom in my area if the above has nothing.


  • What About Satellites?
  • Can I Hear (and maybe talk to) the Astronauts on the International Space Station?
    • Military communications over satellites can occasionally be heard. Note that just about all U.S. military SATCOM voice transmissions are encrypted. Occasionally you can hear short comms in the clear, like voice testing, but this is infrequent. You can also hear telemetry and other constant data streams. More often, you can hear what sounds like casual conversations in languages other than English, but the reason for this is somewhat unclear. A receiver for monitoring SATCOM must coverage from 240 MHz to 270 MHz. While NFM mode is common, many other modes are possible. Software Defined Radios easily fit this requirement. Just like VHF/UHF Milcom, SATCOM uses an interval of 25 kHz. Optimal setups for receiving SATCOM are unique, involving hi gain antennas designed for correct polarization of the SATCOM signal. It is possible to hear SATCOM with nothing more than a handheld and a wideband whip. This technique involves going outside (SATCOM signals are relatively weak), searching the SATCOM frequency range, and experimenting with orienting your whip from vertical to horizontal. Listen carefully for carriers and periodic data bursts. See the SATCOM page for more information about amateur and military satellites, including the International Space Station.

---