Actions

Difference between revisions of "Discriminator output"

From The RadioReference Wiki

Line 17: Line 17:
 
*[[BC895 Tap | BC895XLT Discriminator Tap]]
 
*[[BC895 Tap | BC895XLT Discriminator Tap]]
 
*[[media:Bc996discriminatortap.jpg|BCD996 Discriminator tap point]]
 
*[[media:Bc996discriminatortap.jpg|BCD996 Discriminator tap point]]
*'''NOTE:''' Look dead center of the circuit board, then go right and down.
+
*[[media:Bc996discriminatortap.jpg|BCT15 Discriminator tap point]]
 +
*'''NOTE:''' Look dead center of the circuit board, then go right and down. Both the 996 and BCT15 appear to share the same tap point location.
  
 
'''Radio Shack'''
 
'''Radio Shack'''

Revision as of 05:25, 27 September 2007

The Discriminator output from a scanner is the raw, unfiltered signal that a scanner produces before it is sent to the audio stage for output through the speaker -- also called the "baseband audio." This discriminator source is required for applications such as Trunker, T4Win, and UniTrunker. Most scanners must have a simple modification made to them to feed the discriminator output to Data Slicers, or in the case of UniTrunker, a soundcard.

Note that for providing a signal for ACARS decoding, a connection from an earphone or speaker output is all that's required. This is because ACARS runs at a much lower speed, and the discriminator is not involved in AM reception.

Modifications

Uniden

Radio Shack


Other Radios

Links

These pages or links contain more information on discriminator taps for many brands and models of scanners, including older models