Uniden Scanner Test Modes for the HP Series scanners
From The RadioReference Wiki
Test name | Keys | HomePatrol-1 | HomePatrol-2 | BCD436HP | BCD536HP | SDS100 | SDS200 |
Initialize Memory | 1+0+YES+ON | X | X | X | X |
HomePatrol 1/2
- Power off the unit (All Off)
- Pressing the Volume up & Power at the same time until you first see the boot screen quickly release the two and hold the volume down to enter test modes.
- You'll have access to complete Firmware versions as well as many other tools.
- To return to normal scanning power off unit normally and power back on as usual.
Using ProScan with the SDS100
- Select Test and Extras then Protocol Command. In all cases Power Down to exit
- Enter SDR to see the SDR Demo (basically non functional)
- Enter TST,X,UNIDEN_TEST_MODE Caution: This disconnects the serial port
- X equals the following;
- Software Version Display
- Close Call Test
- Unknown
- NWT / SAME test
- Key Touch / Alert LED / Headphone test
- Unknown
- Tone Out Test
Writing a Debug File with the SDS100
- Power up while holding AVOID.(adds Set Debug Log Mode to settings)
- MENU --> SETTINGS --> Set Debug Log Mode --> SD Card File
- Monitor for a bit (a minute or two is plenty).
- MENU --> SETTINGS --> Set Debug Log Mode --> Off
- File is in the debug directory on the SD card.
Categories:
- Uniden Scanners
- Desktop Scanners
- Handheld Scanners
- Mobile Scanners
- Conventional Scanners
- Analog Trunktrackers
- Rebanding Supported Scanners
- Digital Scanners without DMR
- Digital Scanners without MOTOTRBO
- Digital Scanners without NXDN
- Digital Scanners without ProVoice
- Digital Scanners with DMR
- Digital Scanners with MOTOTRBO
- Digital Scanners with NXDN
- Digital Scanners with ProVoice
- Scanner accessories